Chapter 33-117F-3-762F-3-763When attaching the top cover, be sure to fit the link lever [2] while keepingthe drive release lever [1] in up position (i.e., with drive disengaged).F-3-764If you are fitting the drum cartridge in the machine with the top cover re-moved, be sure to do so with the drive release lever [1] fully in up position(i.e., with drive disengaged).If the drive release lever is in low position (i.e., with drive engaged), it forcesout the coupling [2], causing the coupling to interface with the drum car-tridge and to suffer damage.F-3-7653.5.11.8 Removing the Right Frame 0011-66011) Remove the 5 screws [1], and detach the right frame [2].F-3-7663.5.11.9 Removing the Registration Clutch 0007-88261) Disconnect the connector [1], and open the harness band [2].2) Remove the E-ring [3], and detach the registration clutch [4].F-3-767The connector on the registration clutch side is designed to prevent discon-nection. If you have to detach the registration clutch, be sure to disconnectthe connector (J113) on the DC controller PCB side.3.5.11.10 Removing the Main Drive Assembly 0007-88321) Shift down the drive release lever [1], and remove the gear [2].[1][2]OK NGEnlarged View of the Paper Retainer[3] [3][1][2][1][2][1][1][2][1][2] [3][4]
