Chapter 33-157F-3-101612) Remove the cable [1] from the guide [2].13) Remove the 2 claws [4], and disconnect the connector [3].14) Free the cable from the edge saddle [5].F-3-101715) Remove the 1 screw [1] and slide the fixing separation guide [2] out tothe left.F-3-1018Make sure that all cables on the fixing film unit are hooked into the fixingseparation guide when reassembling the guide. Especially the right-side ca-bles are easy to be pinched unless properlyhooked into the guide.F-3-101916) Lift the fixing film unit [1] up straight in horizontal position to take it outof the fixing unit.F-3-10203.7.3 Fixing Pressure Roller3.7.3.1 Removing the Fixing Assembly 0011-78531) Turn the lever [1] of the fixing assembly 90 deg in the direction of thearrow.2) While holding the grip [2], slide out the fixing assembly [3] toward thefront and out of the machine.Whenever you have to replace the fixing assembly, be sure to disconnect thepower cord first. Also, be sure to wait unit the fixing assembly has cooledbefore removing it after disconnecting the power cord.F-3-10213.7.3.2 Removing the Face-Up Cover 0011-78541) Turn the fixing lever [1] of the fixing assembly 90 deg in the direction ofthe arrow.2) Remove the 4 claws [2], and detach the face-up cover [3] from the fixingassembly.F-3-10223.7.3.3 Removing the Fixing Film Unit 0011-78551) Unhook the 1 claw [1] and remove the pressure roller gear[2].2) Unhook the 1 claw [3] and remove the delivery roller gear[4].3) Remove the idle gear[5].[1][3][2][4][1][2][2][4][3][3][5][1][2][1][2][1][1] [1][3] [2][1] [1][2][3]
