Chapter 33-293.2.16 Print Power Supply PCB3.2.16.1 Removing the Fixing Assembly 0011-78611) Turn the lever [1] of the fixing assembly 90 deg in the direction of thearrow.2) While holding the grip [2], slide out the fixing assembly [3] toward thefront and out of the machine.Whenever you have to replace the fixing assembly, be sure to disconnect thepower cord first. Also, be sure to wait unit the fixing assembly has cooledbefore removing it after disconnecting the power cord.F-3-1853.2.16.2 Removing the Rear Cover 0007-85221) Disconnect the cable [1] of the power supply assembly.2) Open the face-up cover [2], and remove the 4 screws [3] of the rear cover.F-3-1863) Open the reader assembly [4], and lift to free the 2 claws [5].F-3-1874) Close the reader assembly; then, detach the rear cover[1].F-3-1883.2.16.3 Removing the Reader Assembly 0007-85241) Open the reader assembly, and remove the left and right E-rings [1]; then,pull out the pin [2].F-3-189When closing the reader assembly, be sure to push in the arm [1] first.F-3-1902) Open the left and right claws in the direction of the arrows, and detach thehinge cover [1].3) Free the 2 harness bands [1], and disconnect the 2 cables [2] connected tothe reader assembly.[1] [1][3] [2][2][3][1][3][4][5][2][3][1][3][2][1][2][1][1]
