Chapter 33-142F-3-9213.6.7.8 Removing the Right Frame 0011-66051) Remove the 5 screws [1], and detach the right frame [2].F-3-9223.6.7.9 Removing the Shield Plate 0011-65861) Free the flat cable [1] from the connector.2) Remove the 6 screws [2], and detach the shielding plate [3].F-3-9233.6.7.10 Removing the Inside Cover 0007-71181) Remove the 2 claws [1], and detach the inside cover [2].F-3-9243.6.7.11 Removing the Registration Clutch 0007-71251) Disconnect the connector [1], and open the harness band [2].2) Remove the E-ring [3], and detach the registration clutch [4].F-3-925The connector on the registration clutch side is designed to prevent discon-nection. If you have to detach the registration clutch, be sure to disconnectthe connector (J113) on the DC controller PCB side.3.6.7.12 Removing the Main Drive Assembly 0007-90721) Shift down the drive release lever [1], and remove the gear [2].F-3-9262) Remove the 2 screws [1], and detach the front sub cover [2].F-3-927When mounting the main drive assembly, be sure to fit the gear [2] as shownwith the drive release lever [1] in down position (i.e., with drive engaged).At this time, be sure that the position of the gear is correct so that it is fullyengaged with the gear of the drive release lever.F-3-928[1][2][1][1][2][2] [2][3] [1][1][2][1][2] [3][4][1] [2][1][2][1][2]
