Canon MF8100 Series Service Manual

Contents

Canon MF8100 Series Service Manual Manual pdf 115 page image

Chapter 33-25F-3-1553.2.12.10 Removing the DCNT Board 0007-79631) Disconnect the connector [1] connected to the DC controller, and removethe 4 screws [2]; then, detach the DCNT board.F-3-1563.2.13 NCU Board3.2.13.1 Removing the Rear Cover 0007-80601) Disconnect the cable [1] of the power supply assembly.2) Open the face-up cover [2], and remove the 4 screws [3] of the rear cover.F-3-1573) Open the reader assembly [4], and lift to free the 2 claws [5].F-3-1584) Close the reader assembly; then, detach the rear cover[1].F-3-1593.2.13.2 Removing the Scanner Unit 0007-80631) Remove the platen glass cover.2) While removing the left and right claws, detach the hinge cover [1].3) Remove the screw [2], and detach the cable guide [3].F-3-1604) Open the harness band [1], and free the 2 cables [2] connected to thereader assembly.F-3-1615) Remove the 2 screws [1] from the back; then, shift the scanner unit [2] tothe back, and lift it to detach.[2] [2][3] [1][2][2][1][1][1] [1][1][2][3][1][3][4][5][2][3][1][3][2][1][3][2][2] [1]