Copying74 WorkCentre 7500 Series Multifunction PrinterUser GuideBasic CopyingTo make copies:1. On the control panel, press the yellow Clear All button to clear previous copy settings.2. Load your original documents: Use the document glass for single pages or paper that cannot be fed using the documentfeeder. Place the first page of the document face down, in the top left corner of the documentglass. Use the document feeder for multiple or single pages. Remove any staples and paper clips fromthe pages and place them face up in the document feeder.3. Press the Services Home button, then touch Copy.4. Use the alphanumeric keypad on the control panel to enter the number of copies. The number ofcopies appears in the upper right corner of the touch screen.Note: To correct the number of copies entered using the alphanumeric keypad, press the C button,then re-enter the number.5. If desired, change the copy settings. For details, see Selecting Copy Settings on page 76.6. Press the green Start button.Notes: To pause or cancel a copy job, press the red Stop button on the control panel. To interrupt a copy job, press the Interrupt button on the control panel. On the touch screen, touch Resume to continue the job, or Cancel to cancel the job completely.Document Glass Lift the document feeder coverand place the first page facedown in the upper left corner ofthe document glass. The original must be aligned tothe matching paper size printedon the edge of the glass. The document glass acceptspaper sizes up to 310 x 430 mm(12.25 x 17 in.). The document glassautomatically detects standardpaper sizes.
