Faxing138 WorkCentre 7500 Series Multifunction PrinterUser GuideSetting Up Book FaxingYou can determine the method used for scanning images in a book.To select Book Faxing:1. Touch the Layout Adjustment tab, then touch Book Faxing.2. Touch one of the following options: Off is the default setting. Both Pages scans both pages of the book. If necessary, touch the Binding Edge Erase arrows toset the amount to erase from the binding edge. Left Page Only scans the left page of the book. If necessary, touch the Binding Edge Erasearrows to set the amount to erase from the binding edge. Right Page Only scans the right page of the book. If necessary, touch the Binding Edge Erasearrows to set the amount to erase from the binding edge.3. Touch Save.Requesting a Confirmation ReportYou can request a report that confirms when your faxes are sent or received. The report containsinformation on timeouts, busy signals, and retry failures.To set up a Confirmation Report:1. Touch the Fax Options tab, then touch Confirmation Report.2. Touch one of the following options: Always Print generates a report for all fax jobs. Print on Error Only only generates a report for fax jobs that fail to send.3. Touch Save.Selecting the Starting RateSelect the highest starting rate unless the destination for the fax you are sending has specialrequirements.To select the transmission speed for a fax:1. Touch the Fax Options tab, then touch Starting Rate.2. Touch one of the following options: Super G3 (33.6 Kbps) G3 (14.4 Kbps) Forced (4800 bps)3. Touch Save.Sending a Delayed FaxYou can set a time in the future for the printer to send your fax job. The time delay can be from 15minutes to 24 hours from the current time.
