Installation and Setup34 WorkCentre 7500 Series Multifunction PrinterUser Guide1. Insert the Software and Documentation disc into the appropriate drive on your computer.2. Open the Mac folder, then open Mac OS 10.4+Universal PS folder.3. Open Xerox ® WorkCentre WC75xx CD.dmg.4. Double-click to run WorkCentre WC75xx CD.mpkg.5. Click Continue for the next three windows.6. Click Agree to accept the license agreement.7. Click Install to accept the current installation location, or select another location for the installationfiles, then click Install.8. Enter your password, then click OK.9. Select your printer in the list of discovered printers, then click Continue.10. If your printer does not appear in the list of discovered printers:a. Click the Network Printer Icon.b. Type the IP address of your printer then click Continue.c. Select your printer in the list of discovered printers, then click Continue.11. Click OK to accept the print queue message.12. Select or clear the Set Printer as Default and Print a Test Page check boxes.13. Click Continue, then click Close.Note: The printer is automatically added to the printer queue in Macintosh OS X version 10.4 andlater.To verify the installation of printer options with the print driver:1. From the Apple menu, open System Preferences > Print & Fax.2. Select the printer in the list, then click Options and Supplies.3. Click Driver, then confirm that your printer is selected.4. Confirm that all of the options installed on the printer appear correct.5. If you change settings, click Apply Changes, close the window, and quit System Preferences.Installing Drivers and Utilities for UNIX and LinuxXerox® Services for UNIX Systems is a two part installation process. It requires the installation of a Xerox ®Services for UNIX Systems code package and a printer support package. The Xerox ® Services for UNIXSystems code package must be installed before installing the printer support package.Note: You must have root or superuser privileges to perform the UNIX print driver installation on yourcomputer.1. At the printer, do the following:a. Verify that both the TCP/IP protocol and the proper connector are enabled.b. On the printer control panel, do one of the following for the IP address: Allow the printer to set up a DHCP address. Enter the IP address manually.
