Samsung OfficeServ 7100 Technical Manual

Also see for OFFICESERV 7100: Quick guide System administration guide User guide User manual User guide

Contents

OfficeServ 7100 PROGRAMMINGTECHNICAL MANUAL PART 5 APRIL 20075.3.49GENERAL SCREEN:Field Name DescriptionLabel Name The name of this Port blockLine is wink start (DO NOT ADJUST)Wait for loop current (DO NOT ADJUST)Rings beforeanswer(DO NOT ADJUST)Hunt group type This should match the ring type setting in MMC 601. If MMC 601 isset to Sequential, this setting should be 'Linear'. If MMC 601 is setto Distributed, this setting should be 'Rotating'Disconnect signal This setting is mainly provided to overcome issues with COdisconnect signaling. In some cases, the CO does not send theOfficeServ 7100 a proper disconnect signal, which can result inthe subscriber getting messages with dial tone or error tone at theend. This field allows the system to look for a different type ofdisconnect signal, such as dial tone or fast busy.Toll saver group (DO NOT ADJUST)Toll saver rings (DO NOT ADJUST)Toll saver prompt (DO NOT ADJUST)Auto clear MWI (DO NOT ADJUST)