7878[Image compression rate upon alarm detection]Select "On" or "Off" to determine whether or not tochange the image quality of the quality 1 upon alarmdetection.On: Images will be transmitted with the image qualityselected for "Image quality upon alarm detection".Off: Does not change the image quality upon alarmdetection.Default: Off[Image quality upon alarm detection]Image quality can be changed upon an alarm occur-rence. Select the image quality from the following.0 Super fine/ 1 Fine/ 2/ 3/ 4/ 5 Normal/ 6/ 7/ 8/ 9 LowDefault: 5 NormalConfigure the settings relating to H.264 recording [Alarm]Click the [Alarm] tab on the "Alarm" page. (☞ Pages 26 and 27: How to display/operate the setup menu)The settings relating to the recording H.264 data on the SD memory card when an alarm is detected can be config-ured on this page. To operate recording, it is necessary to configure the settings relating to SD memory card andthe moving picture data. (☞ Page 33)■ H.264 recording[Pre alarm]Determine whether or not to perform the pre-alarmrecording. When "Use" is selected, 1 MB image data isalways saved during the pre alarm recording.Use/ Not useDefault: Not use[Post alarm (recording) duration]Set the duration to save image data on the SD memorycard after an alarm occurrence.10s/ 20s/ 30s/ 40s/ 50s/ 60s/ 120s/ 180s/ 240s/ 300sDefault: 30s* The actual recording time may sometimes be longerthan the duration selected for this setting.[Recording (memory) Size per an alarm]The capacity of the SD memory card used to recordvideo data upon an alarm occurrence. The actualcapacity may be different.Important:• To record H.264 data, it is required to select "Use"for "SD memory card" on the [SD memory card] tab.In addition, it is select "H.264" for "Recording for-mat". (☞ Page 33)
