121Maintenance of the camera [Maintenance]System log check, firmware upgrade, status check and initialization of the setup menu can be performed on thispage.The "Maintenance" page has 4 tabs; the [System log] tab, the [Upgrade] tab, [Status] tab and the [Default reset]tab.Check the system log [System log]Click the [System log] tab of the "Maintenance" page. (☞ Pages 26 and 27: How to display/operate the setupmenu)Up to 4 000 system logs can be saved on the SD memory card when the SD memory card is inserted after select-ing "Use" for "SD memory card" on the [SD memory card] tab (☞ page 33).When "Not use" is selected for "SD memory card", up to 100 system logs can be saved on the built-in memory ofthe camera.When the saved system logs have reached the maximum number, the newer logs will overwrite the older systemlogs. In this case, the oldest log is the first to be overwritten.The system logs will be displayed in group of 100 logs each.When using the SD memory card, the logs will be saved even when the power of the camera is turned off. Whennot using the SD memory card, the logs will be deleted when the power of the camera is turned off.[Next 100 >>]When clicking "Next 100 >>", the next 100 system logswill be displayed.[<< Previous 100]When clicking "<< Previous 100", the previous 100 sys-tem logs will be displayed.[No.]The serial number of the system log will be displayed.[Time & date]Time and date at the error occurrence will be displayed.Note:• When "Off" is selected for "Time display format" onthe [Basic] tab (☞ page 30), time & date of logs willbe displayed in 24-hour format.[Description]The descriptions about the system log will be dis-played.Refer to page 127 for further information about the sys-tem logs.
