7070Configure the settings relating to the auto pan function ("Auto pan" setupmenu)Click the [Setup>>] button of "Auto pan" on the [Image/Position] tab of the "Image/Audio" page (☞ page 58).The settings relating to the auto pan function can be configured with the setup menu displayed in a newly displayedwindow.■ Position[Start position]Move the camera to the desired point to be set as thestart point of the auto panning using the control pad/buttons and adjust the image using the [Zoom] buttonsand the [Focus] buttons.The zoom and focus settings are set together with thestart point.Note:• Panning, tilting and zooming operations can also becarried out on the [Image/Position] tab.• Adjusted zoom and focus position for the auto panfunction will be applied when [Set] button of "Startposition" is clicked.[End position]Move the camera to the desired point to be set as theend point of the auto panning using the control pad/buttons, and then click the [Set] button to register theposition as the end position.■ Auto pan[Dwell time]Select a dwell time at the start point and the end pointfrom the following.5s/ 10s/ 20s/ 30sDefault: 5s[Speed]Select a speed for the auto panning from the following.3°/s, 4°/s, 5°/s, 7°/s, 10°/s, 13°/s, 18°/s, 24°/sDefault: 13°/sImportant:• When "Dwell time" or "Speed" is edited, it is neces-sary to click the [Set] button to apply them.Note:• Even when the selected zoom factor is higher than36x, the camera will start panning with 36x zoomfactor.[Zoom] buttons, [Focus] buttons, [Brightness] but-tons, Control pad/buttons and [Go] buttonRefer to pages 9 and 11 for descriptions of how tooperate these buttons/pad.[Close] buttonClick this button to close the "Auto pan" setup menu.
