Panasonic TH-55AF1U Operating Instrctions

Also see for TH-42AF1U: Operating instructions Operating instructions

Contents

Panasonic TH-55AF1U Operating Instrctions Manual pdf 95 page image

95EnglishInformation timingSet up the informing manner for no signal ortemperature rising.During RS-232C controls:Warning or error message sent on the displayautomatically.During LAN controls:Acquire the warning or error message from thedisplay.1 Select the item with .Select the set point with .Information timingNo signal warningNo signal warning timingTemperature warningNo signal errorNo signal error timingOn5minOn10minOn[No signal warning]When set to [On], the display sends out the no signalwarning.[No signal warning timing]Set up the detecting time for no signal warning.(Range: 01 - 60, Interval: 1 minute)[No signal error]When set to [On], the display sends out the no signalerror.[No signal error timing]Set up the detecting time for no signal error.(Range: 01 - 90, Interval: 1 minute)● The warning of [No signal warning] and the errorof [No signal error] are not sent when the no signalstate is detected through any of the followingfunctions:[No signal power off], [HDMI1 power management],[HDMI2 power management], [DVI-D powermanagement], [PC power management] (see page81)Setting Example:[No signal warning timing]: 5 minutes[No signal error timing]: 10 minutesNote● The [No signal error timing] cannot be set shorterthan [No signal warning timing].[Temperature warning]When set to [On], the display sends out the warningmessage.Note● With the USB input, the unit determines videosignals are interrupted by judging the USB memoryis not connected to the USB terminal.Power on screen delayYou can set the power-on delay time of the displays toreduce the power load, when you press

On / Off button> to turn on the multiple displays that areset together.Set each display’s setting individually.[Off]:The display will be turned on at the same time as

is pressed.[Auto]:Sets the delay time automatically according to thenumber set for [Display ID].The delay time is determined by multiplying[Display ID] × 0.3 seconds.Example:When [Display ID] is 3 → 0.9 seconds1 to 30:Set the power-on delay time (second).After pressing

,the display will be powered on with time delaydepending on this setting.Note● While this function is working, the power indicator isblinking green.● This function also works when the power recoversfrom failure or after plugging off and in again thepower cord.● Even if [OpenPort PLATFORM standby] (see page83) is set to [On], when starting up in standby statuswhere the power indicator is off or illuminating inred, OpenPort PLATFORM has not started yet whileoperating with startup delay. Therefore, if the poweris turned off using the remote control during this time,the unit enters the standby mode with the powerindicator illuminating in red.Clock displaySets to display / hide the clock.[Off]:Hides the clock.[On]:Displays the clock.Note● The clock is displayed at the lower left of the screenwhen button is pressed.● When current date and time is not set, the clock isnot displayed even when [Clock display] is [On]. (seepage 59)