English32Note● Even if the display unit is turned off with the powerindicator off, some of the circuits are in power-onstatus.● When the power indicator is orange, powerconsumption during standby/sleep is generallylarger than that of when the power indicator is red.● When the power indicator is changing from greenshowing the picture is displayed to red or off, whilethe OpenPort PLATFORM system is shutting down,the indicator temporarily illuminates in orange. Inthis status, the remote control operation is ignored.● When the is pressedwhile the power indicator is lighting in orange(standby or sleep status), the power indicator blinksonce, and then the shutdown processing of theOpenPort PLATFORM system (see page 40) isperformed.When the shutdown is complete, the powerindicator goes off.Identifying ControlsMain unit● To take out/store the power indicator and remotecontrol sensor, operate the lever on the rear panel.It is also possible to press the remote controlsensor directly to store.Note● For normal use, pull out the power indicator andremote control sensor from the edge side of themain unit by operating the lever on the rear panel.Depending on the setup condition such as whenusing the multi display, store them in the main unit.1 Power Indicator / Remote control sensorThe Power Indicator will light.When the power of the unit is ON (Main Power On/ Off button: ON)● Picture is displayed: Green● Power OFF (standby) with remote control:• When [OpenPort PLATFORM standby] is set to[Off]: Red• When [OpenPort PLATFORM standby] is set to[On]: Orange (Red/Green)About [OpenPort PLATFORM standby] settings,see page 83.● Power OFF (sleep) with “Power management”function: Orange (Red/Green)About “Power management” function, see page 81.When the power of the unit is OFF (Main PowerOn / Off button: OFF): No light
