Panasonic TH-55AF1U Operating Instrctions

Also see for TH-42AF1U: Operating instructions Operating instructions

Contents

Panasonic TH-55AF1U Operating Instrctions Manual pdf 94 page image

English94Off-timer functionEnables / disables Off timer function.[Enable]:Enables the [Off-timer function].[Disable]:Disables the [Off-timer function].Note● When [Disable] is set, the Off-timer is cancelled.Initial startupSets the power mode of the unit for when the powerrecovers from failure or after plugging off and in again.[Last memory]:Power returns in as the same state as before thepower interruption.[On]:Power returns in power On.(Power Indicator: green)[Standby]:Power returns in standby mode.(Power Indicator: red/orange)Note● When using multiple displays, [Standby] is preferredto be set in order to reduce a power load.Startup logoSets to display / not to display the Panasonic logo on thescreen when the display is turned on.[Off]:Panasonic logo is not displayed.[On]:Panasonic logo is displayed.Note● For the OpenPort PLATFORM startup screen, seepage 40.Display IDSets ID number when controlling the Display with[Controller ID function] and [Serial ID function].0 - 100 (Standard value: 0)Controller ID functionEnables/Disables the ID remote control function.To operate this function, please purchase ID remotecontroller sold separately. (see page 109)[Off]:Disables the ID remote control function. (Can beoperated as normal remote control.)[On]:Enables the ID remote control function.Effective on switching to [On].Note● To use the ID remote control function, setting IDnumbers both for the remote control and for thedisplay unit is required.For ID number setting for the remote controland display unit, see page 109 and [Display ID]respectively.Serial ID functionSet to control external control with the PC connected toSERIAL terminal according to the Display’s ID number(Panel ID).[Off]:Disables external control by the ID.[On]:Enables the external control by the ID.Serial response(ID all)Sets whether to respond to the command or not, whenserial command of ID No “0” is received.[Off]:Does not respond.[On]:Responds.Serial daisy chain positionSet the first and last terminals in the chain when theSERIAL IN/OUT terminal of this unit is connected usinga daisy chain scheme.[---]:When controlling this unit alone with serial control,or connecting at a position other than the first andlast terminals in a daisy chain[Top]:When connecting at the first terminal in a daisychain[End]:When connecting at the last terminal in a daisychain