Panasonic TH-55AF1U Operating Instrctions

Also see for TH-42AF1U: Operating instructions Operating instructions

Contents

Panasonic TH-55AF1U Operating Instrctions Manual pdf 80 page image

English80■ [Input level]This menu is displayed at PC IN, COMPONENT/RGBIN and VIDEO IN inputs.Adjustment of parts which are extremely bright andhard to see.- 16 to + 16:(Level low) - (Level high)■ [3D Y/C filter]Set this if the video looks unnatural at VIDEO INinput. Set this to [On] normally.Note● Depending on the signalling system, this settingmay be less effective or may not be effective at all.■ [Colour system]Sets the colour system according to the signalmethod at VIDEO IN input. Set this to [Auto] normally.This automatically detects the input signal format.[Auto], [PAL], [SECAM], [NTSC], [NTSC 4.43], [PALM], [PAL N]:Set this to [Auto] when viewing PAL-60 videos.When images are unstableWhen the system is set to [Auto], images becomeunstable in rare case under the condition that theinput signals are at low level or have many noises.In this case, set the system so it conforms with theinput signal format.■ [Dynamic backlight control]Improves picture contrast and alleviates whitenessby controlling the back light when signals with the lowaverage brightness level (APL) are input.[On]:The function is enabled.[Off]:The function is disabled.Note● When this function is operating, the on-screenbrightness becomes lower.● If the [Dynamic backlight control] setting is differentfor each input, the on-screen brightness may changeby switching input.● Depending on the displayed image, the screen mayflicker. If this annoys you, set [Dynamic backlightcontrol] to [Off].■ Input signal displayDisplays the frequency and the type of the currentinput signal.60.00 Hz74.18 MHz1125(1080)/60i33.72 kHzH-freq.V-freq.Dot clock freq.Signal formatDisplay range:Horizontal (15 kHz - 135 kHz)Vertical (24 Hz - 120 Hz)The dot clock frequency is displayed when Digital andPC signal are input.Screensaver(For preventing image retention)Do not display a still picture, especially in 4:3 mode, forany length of time.If the display must remain on, a Screensaver should beused.[Screensaver] - submenu screenScreensaverStart10:00Mode OffFRIDAY2016/01/01■ Screensaver settingsScreensaver operationWhen the Screensaver is operating, the following 5patterns are displayed full screen for 5 seconds each,and it will be repeated.Black → Dark grey → Grey → Light grey → White →Light grey → Grey → Dark greyTo start Screensaver nowSelect [On] in [Mode].Select [Start] and press .● The Screensaver will be activated.ScreensaverStart10:00Mode OnFRIDAY2016/01/01Note● If the following buttons are pressed while thescreen saver is operating, the screen saver iscancelled.Remote control: Main unit: <+ (Unit)> <- (Unit)>● When the display is turned off, the Screensaver willbe deactivated.To set interval of ScreensaverSelect [Interval] in [Mode].Set [Periodic time].● Press to change the time by 15 minutes.● In [ENGLISH(US)] OSD language, [Periodictime] is displayed as [SHOW DURATION].Set [Operating time].● Press once to change the time by 1 minute.Keep pressing down to change the time by 15minutes.● In [ENGLISH(US)] OSD language, [Operatingtime] is displayed as [SAVER DURATION].