English30USB (OpenPort PLATFORM) terminalconnectionBy attaching a USB memory (commercially available)to the USB (OpenPort PLATFORM) terminal, use it asexternal storage for OpenPort PLATFORM system. (seepage 47)With OpenPort PLATFORM input, it is possible toconnect and use USB devices such as a USB mouse, aUSB keyboard, etc. (see page 43, 44)Note● USB memory, USB device and cable shown are notsupplied with this unit.USBOpenPortPLATFORMUSB memoryUSB mouse (commercially available)Pin assignments and signal names for USB(OpenPort PLATFORM) Terminal1 3 42Pin No. Signal Name+5 V DCDATADATAGND (Ground)Each USB (OpenPort PLATFORM) terminal is capableof supplying power of up to 5V/500mA to an externaldevice when the picture is displayed or it is in standbycondition (Power Indicator: Orange) (see page 32).● If the electric current exceeding the power supplyingcapability is applied, the output is blocked, and thefollowing message is displayed on the screen.(In standby condition, the message is displayed whenthe picture is displayed next time.)[USB DC5V OUT overload (OpenPort PLATFORM).Please remove cable or equipment, then turn thedisplay off/on.]In this case, remove the connected equipment, andthen turn the power off/on with the Off button>.■ About compatible USB memory● Commercially available USB memory devices arecompatible. (The ones with security function are notcompatible.)● Only the Fat16-formatted ones and FAT32-formattedones can be used on this unit.● The maximum memory size of USB is 32 GB.● Only a single partition configuration is supported.Note● When removing a USB memory, unmount the USBmemory. (see page 57)● Depending on the type of a USB memory device,it may come in contact with the periphery suchas a back cover, and cannot be attached. Use acommercially sold extension cable, or use a smalltype of a USB memory device connectable to thisunit.● If the direct connection to this unit is not possible dueto the size of the USB device, use a commerciallysold extension cable.