English38Volume AdjustmentPress or <+ (Unit)> <- (Unit)> toadjust volume.INPUTMENUENTERUnit20Volume (SPEAKERS)● The current sound volume level is memorised even ifthe power is turned off.● When [Maximum VOL level] is set to [On], the volumecan only be adjusted to the maximum point you set,and the displayed value turns red when it reached itsmaximum. (see page 93)● When [Initial VOL level] is set to [On], the volume willbe at the set level when the display is turned on. (seepage 92)Sound mute On / OffIt is useful when you want to mute the sound temporarily,for example, when answering the phone or door.Press .● appears on the screen and the sound is muted.Press again to reactivate the sound.● It is also reactivated when the power is turned on / offor the volume level is changed.● While MUTE is active, is displayed as a reminderafter operation.● In [ENGLISH(US)] OSD language, is displayed as[MUTE].Note● Displays the signal name as set in [Input label]. (seepage 81)● Input will not be switched unless [Input lock] is set to[Off]. (see page 93)● Image retention (image lag) may occur on the LCDdisplay panel when a still picture is kept on the panelfor an extended period. To prevent such a problem,using the screensaver and wobbling is recommended.(see page 80, 83)RECALLIt is possible to check the setting status of input label,picture mode, etc.Press .Current setting status will be displayed.1234567PC16:9Backup mode OKAUDIO1 INMemory name: MEMORY 2Off timer 90 min1 Input label2 Aspect mode (see page 64)3 Backup input change (see page 90)4 Audio input (see page 92)5 Profile name (see page 75)6 Off timer remaining time (see page 39)7 Clock / Mute (see page 38, 59)● The followings are displayed for about 30 seconds atthe end: [No signal] - when there is no video signal tothe selected input, [No external media] - when a USBmemory is not connected to the USB terminal at thetime of using the USB input.During the OpenPort PLATFORM input, “no signal” isnot discriminated.● To display the clock, set [Date & time] in OpenPortPLATFORM, and then set [Clock display] to [On].(see page 59, 95)
