109EnglishID Remote ControlFunctionYou can set the remote control ID when you want to usethis remote control on one of several different displays.In that case, you need to set the remote control’s IDnumber to match the Display’s ID number you have setin [Display ID] following the steps below.Note● To operate this function, please purchaseID remote controller sold separately.Object model: N2QAYA000093● When operating the OpenPort PLATFORM parton this ID remote control, the button, button and number <6> button operateas the button, button and button respectively.Setting the remote control’s IDnumber1 Set [Controller ID function] to [On].(see page 94)● While displaying [Options] menu, you can operateeven if the ID does not match.2 Set the remote control’s switch to .3 Pointing the remote control at theDisplay you want to control, press SET>.0?ID setDisplay IDController ID4 Press one of <0> - <9>.Sets the tens digit.5 Press one of <0> - <9>.Sets the units digit.● The steps from 3 to 5 need to be done within 5seconds.● Adjustable ID number range is 0 - 100.Example:• To set the ID to “1”: After step 3, press <0> andthen <1>.• To set the ID to “12”: After step 3, press <1>and then <2>.• To set the ID to “100”: After step 3, press <1><0> <0>.Cancelling the setting of remotecontrol’s ID number (ID “0”)You can operate even if the ID does not match the ID setin [Display ID].Press for more then 3 seconds.This has the same effect as pressing <0><0>.Note● The ID remote control cannot be used when [DisplayID] is set to anything other than “0”, and the remotecontrol ID is not the same as the [Display ID] number.(see page 94)
