Panasonic TH-55AF1U Operating Instrctions

Also see for TH-42AF1U: Operating instructions Operating instructions

Contents

Panasonic TH-55AF1U Operating Instrctions Manual pdf 35 page image

35EnglishBasic ControlsRemote Control Sensor /Power IndicatorMain Power On / Off button(Back of the unit)AC socket outletAC cord (supplied)Operate pointing the remote control directly atthe unit’s Remote Control Sensor.Note● For normal use, pull out the remote control sensorfrom the edge side of the main unit by operating thelever on the rear panel. (see page 32)● Do not put an obstacle between the remote controlsensor of the main unit and the remote control.● Operate the remote control in front of the remotecontrol sensor or from the area where the sensor canbe seen.● When directly aiming the remote control at the remotecontrol sensor of the main unit, the distance fromthe front of remote control sensor should be approx.7 m or less. Depending on the angle, the operationdistance may be shorter.● Do not subject the remote control sensor of the mainunit to the direct sunlight or strong fluorescent light.1 Connect the AC cord plug to theDisplay.(see page 18)2 Connect the plug to the socket outlet.Note● Main plug types vary between countries. Thepower plug shown at left may, therefore, not be thetype fitted to your set.● When disconnecting the AC cord, be absolutelysure to disconnect the AC cord plug at the socketoutlet first.● The settings may not be saved if the power plug isdisconnected immediately after changing settingswith on-screen menu. Disconnect the power plugafter a enough period of time. Or, disconnect thepower plug after turning the power off with theremote control, RS-232C control or LAN control.3 Press the

button> on the unit to turn the set on:Power-On.● Power Indicator: Green (Picture is displayed.)● When the power of the unit is ON, remote controloperation is possible.■ To turn the power ON/OFF with the remotecontrolPress the to turn theDisplay on.• Power Indicator: Green (Picture is displayed.)Press the to turn theDisplay off.When [OpenPort PLATFORM standby] is set to [Off]• Power Indicator: Red (standby)When [OpenPort PLATFORM standby] is set to [On]• Power Indicator: Orange (Red/Green) (standby)(About [OpenPort PLATFORM standby] settings, seepage 83.)■ To turn the power OFF with the Power On / Off button>● When the power of the unit is ON (Picture isdisplayed: Power indicator in green):Pressing the

willilluminate the power indicator in orange. When it goesoff, the display unit turns off.While the indicator is illuminating in orange, theremote control operation is ignored.