Panasonic TH-55AF1U Operating Instrctions

Also see for TH-42AF1U: Operating instructions Operating instructions

Contents

Panasonic TH-55AF1U Operating Instrctions Manual pdf 14 page image

English14Avoid using the Display in locations prone to staticelectricity.● If the Display is used in a location prone to staticelectricity, such as on a carpet, the wireless LAN orwired LAN connection may be lost.● If this happens, eliminate the source of staticelectricity or electromagnetic noise and reconnect tothe wireless LAN or wired LAN.Using the Display outside the country● It is forbidden to take the Display outside the countryor region where you purchased it, so use it only inthe said country or region. Also, note that dependingon countries or regions there are restrictions on thechannels and frequencies at which you can use thewireless LAN.Available wireless LAN channels● The channels (frequency range) that can be useddiffer according to the country or region. Refer to thetable below.Country or region: GlobalChannels used: Passive scanningStandard Frequency band(Centre frequency)IEEE802.11a/n 5.180 GHz - 5.825 GHzIEEE802.11b/g/n 2.412 GHz - 2.472 GHz• The frequency and channel differ depending on thecountry.• The passive scanning is performed by changing radioto the channel being scanned in each country.• Please use the wireless LAN feature in compliancewith the laws of each country.For Mexico:Operation of this equipment is subject to the followingtwo conditions:(1) this equipment might not have a harmfulinterference and(2) this equipment must accept any interference,including one that might cause it to malfunctionFor Jamaica:• This product contains Type Approved Modules byJamaica.LCD DisplayDeclaration of Conformity (DoC)“Hereby, Panasonic Corporation declares that thisDisplay is in compliance with the essential requirementsand other relevant provisions of the Directive 1999/5/EC.”If you want to get a copy of the original DoC of thisDisplay, please visit the following website:http://www.doc.panasonic.deAuthorized Representative:Panasonic Testing CentrePanasonic Service Europe, a division of PanasonicMarketing Europe GmbHnWinsbergring 11, 22525 Hamburg, GermanyThis Display is intended to be used in the followingcountries.Albania, Austria, Belgium, Bulgaria, Cyprus, CzechRepublic, Denmark, Estonia, Finland, France, Germany,Greece, Hungary, Italy, Iceland, Latvia, Lithuania,Luxembourg, Malta, Netherlands, Norway, Poland,Portugal, Romania, Slovakia, Slovenia, Spain, Sweden,Switzerland, Turkey, United KingdomThe wireless LAN feature of this Display shallexclusively be used inside buildings.UAEUAE-TRAREGISTERED No:ER0081229/12DEALER No:DA0052708/10SingaporeComplies withIDA StandardsDB01017Thailand“เครื่องโทรคมนาคมและอุปกรณ์นี้มีความสอดคล้องตามมาตรฐานทางเทคนิค เลขที่ กทช. มท. 1012-2551”Notes on Using Wired LANWhen setting up the Display at a place, whereelectric statistic occurs often, take a sufficientantistatic measure before start using.• When the Display is used at a location, where staticelectricity occurs often, such as on a carpet, a wiredLAN communication is disconnected more often.In that case, remove static electricity and the noisesource that may cause problems with an antistaticmat, and re-connect the wired LAN.• In rare cases, the LAN connection is disabled dueto static electricity or noise. In that case, turn off thepower of the Display and the connected devices onceand then re-turn on the power.The Display may not work properly due to strongradio wave from the broadcast station or the radio.• If there is any facility or equipment, which outputsstrong radio wave, near the installation location, setup the Display at a location sufficiently far from thesource of the radio wave. Or, wrap the LAN cableconnected to the LAN terminal by using a piece ofmetal foil or a metal pipe, of which is grounded atboth ends.