4.3 ConnectFeature Guide 2434.3.3 Connect—ModemConnects to the PBX in Interactive mode through the modem.To access the PBX remotely using this feature, an RMT card must be installed and the analog remotemaintenance floating extension number assigned. For more details, see "4.16.3 Miscellaneous [10-3]".The settings are as follows:The functions of the buttons on this screen are as follows:Setting Values DescriptionProfile Name – Enter a name used to identify this set ofvalues.Port COM1–COMx Specify the number of the COM portassigned to the PC's modem interface.Only available COM ports will bedisplayed.NL Code CR, CR+LF Specify the code to be sent to signify theend of a line. Choose CR+LF.Baud Rate 1200bps, 2400bps,4800bps, 9600bps,19200bps, 38400bpsSpecify the speed of data transmission.Flow Control None, Hardware Specify whether the rate of data transferis managed by hardware or not. ChooseHardware.Command – Enter the modem initialize command.For more details, refer to your modem'sinstruction manual.Dial Number 1-9, 0, *, and # Enter the telephone number to be dialedto access the PBX.Dial Type Auto(Tone),Auto(Pulse), ManualSpecify the outgoing dialing method.If Manual is chosen, dialing must bedone with a connected telephone.Password – Enter the password corresponding to theProgrammer Code used to log on to theMaintenance Console.Save Password Checked, not checked Select whether to save the passwordwhen the profile is saved.Comment – Enter a comment to help to identify thisprofile.Button FunctionSave Saves the current profile information.Delete Deletes the current profile information.
