1.15 Optional Device Features112 Feature Guide• Each OGM can be assigned a name to be used as a reference while programming. (→ OutgoingMessage (OGM) Name [731])• Account Code Entry (→ 1.5.4.3 Account Code Entry) can be used when making a CO line call via DISA.Installation Manual References2.5.3 MSG2 CardFeature Guide References1.1.1.4 Intercept Routing1.1.1.5 Intercept Routing—No Destination1.3.1 Call Forwarding (FWD)/Do Not Disturb (DND)2.2.5 Operator FeaturesUser Manual References1.2.7 Direct Inward System Access (DISA)1.2.8 Remote Setting1.15.7 Automatic Fax TransferDescriptionThe PBX can distinguish between fax calls and other types of calls arriving on DISA lines, and automaticallytransfer fax calls to preprogrammed destinations. When a call arrives on a DISA line, an OGM is played (→1.15.5 Outgoing Message (OGM)). At the same time, the PBX begins fax signal detection. If a fax signal isdetected, the PBX recognizes that the call is a fax call, and transfers the call to the fax destination assignedto that OGM through system programming. This allows a single CO line to be used seamlessly for both voiceand fax calls, with only voice calls arriving at user extensions.[Available Automatic Fax Transfer Destinations]Destination AvailabilityWired ExtensionPSICD GroupPS Ring GroupVM Group (DTMF/DPT)External Pager (TAFAS)DISAAnalog Remote MaintenanceIdle Line Access no. + Phone no.CO Line Group Access no. + CO Line Group no. + Phone no.
