Setting Item Description, InstructionsPaper Details (The type of pa-per is displayedhere.)(*1 →P.658 )Vac-uumStrngthSpecify the level of suction that holds paper against the Plat-en. (See "Adjusting the Vacuum Strength (Vac-uumStrngth).") →P.622Scan WaitTimeSpecify the time to wait for the ink to dry between each scan(after the printhead finishes moving in one direction), in con-sideration of how quickly the ink dries. Also specify the ap-plicable area for the ink drying time. Select Entire area toapply the ink drying time after each scan until the documentis fully printed. Select Leading edge to apply the ink dryingtime after each scan only in the area 110–140 mm from theleading edge. (The applicable length varies depending on thePrint Quality setting.) Note that printing will take longer ifyou specify the Scan Wait Time setting. In particular, whenLeading edge is selected, colors may be uneven in the boun-dary between the areas with and without a drying time.Roll Drying-TimeSpecify the time to wait for the ink to dry for each sheet.NearEndRollMrgnSpecify the minimum margin at the leading edge of roll pa-per to ensure better printing quality at the leading edge.Note that if you choose 3mm, it may lower the printing qual-ity at the leading edge and affect feeding accuracy. The prin-ted surface may be scratched, and ink may adhere to theleading edge. It may also cause the Platen to become soiled.NearEnd ShtMrgnSpecify a margin at the leading edge of sheets to ensure bet-ter printing quality at the leading edge.Note that if you choose 3mm, it may lower the printing qual-ity at the leading edge and affect feeding accuracy. The prin-ted surface may be scratched, and ink may adhere to theleading edge.Bordless Mar-ginAdjust the margin during borderless printing.Choose Automatic to have the printer automatically detectthe paper width and configure the margin settings for border-less printing. If margins are mistakenly created when Auto-matic is selected, choose Fixed. In this case, the paper widthis not detected automatically, and the document is printedwithout borders, using the margin settings required by theprinter.Width Detec-tionSpecify this option to print inside boundaries or in other ca-ses when specifying a particular starting position for print-ing. (See "Printing From a Desired Starting Point.")→P.598Paper width and skew are not detected if you select Off. Ifpaper is loaded askew, note that paper jams or Platen soilingmay occur.Return De-faultsChoose OK to restore Paper Details to the default values.Paper Details Print the paper settings as specified in Paper Details.Keep Paper Type Select On when printing on a particular type of paper regu-larly. (See "Changing the Type of Paper.") →P.575Printer Parts > Control Panel >iPF650 Menu Settings8657
