Additionally, two modes are available in both AdjustmentPrint and Change Settings : A:High or B:Standard/Draft.Choose the mode that suits your particular printing application.• A:HighThis setting is applied when Highest or High is selected in Print Quality in the printer driver.• B:Standard/DraftThis setting is applied when Standard or Draft is selected in Print Quality in the printer driver.Note• Always check the Adj. Priority values before using Adjust Length. (See "Selecting a Feed Amount Ad-justment Method (Feed Priority).") →P.615• Use paper of the same type and size for adjustment as you will use for printing.Paper to PrepareRolls • An unused roll at least 10 inches wide• High-precision rulerSheets • One sheet of unused paper of at least A4/Letter size• High-precision rulerPerform adjustment as follows.1. Load the paper.• Attaching the Roll Holder to Rolls →P.568• Loading Rolls in the Printer →P.572• Loading Sheets in the Printer →P.594Note• Always make sure the loaded paper matches the type of paper specified. Adjustment cannot be com-pleted correctly unless the loaded paper matches the settings.2. On the Tab Selection screen of the Control Panel, press ◀ or ▶ to select the Settings/Adj. tab ( ).Note• If the Tab Selection screen is not displayed, press the Menu button.3. Press the OK button.The Set./Adj. Menu is displayed.4. Press ▲ or ▼ to select Adjust Printer, and then press the OK button.5. Press ▲ or ▼ to select Feed Priority, and then press the OK button.Adjustments for Better Print Quality > Adjusting the feed amount >iPF650 Adjusting Line Length (Adjust Length)7621
