• Auto(OtherPaper)Use this mode with paper not in the Paper Reference Guide, or if Auto(GenuinePpr) does not eliminate banding.(See "Types of Paper.") →P.562Note• Always check the Adj. Priority values before using Auto(GenuinePpr) or Auto(OtherPaper).(See "Selecting a Feed Amount Adjustment Method (Feed Priority).") →P.615• Adjustment is not possible with Auto(GenuinePpr) and Auto(OtherPaper) when using highly transparentmedia.In this case, use Manual adjustment.(See "Manual Banding Adjustment (Adj. Quality).") →P.618• If additional fine-tuning is necessary after Auto(GenuinePpr) and Auto(OtherPaper), execute Adj. FineFeed.(See "Fine-Tuning the Paper Feed Amount (Adj. Fine Feed).") →P.620• Use Adjust Length to ensure that lines in CAD drawings are printed at exactly the right length.(See "Adjusting Line Length (Adjust Length).") →P.620• This may take some time, depending on the type of paper.• Use paper of the same type and size for adjustment as you will use for printing.Paper to PrepareRolls An unused roll at least 10 inches wideSheets Auto(GenuinePpr) : One sheet of unused paper of at least A4/Letter sizeAuto(OtherPaper) : Two sheets of unused paper of at least A4/Letter size (or one sheet when using A2 orlarger)Perform adjustment as follows.1. Load the paper.• Attaching the Roll Holder to Rolls →P.568• Loading Rolls in the Printer →P.572• Loading Sheets in the Printer →P.594Note• Always make sure the loaded paper matches the type of paper specified. Adjustment cannot be com-pleted correctly unless the loaded paper matches the settings.2. On the Tab Selection screen of the Control Panel, press ◀ or ▶ to select the Settings/Adj. tab ( ).Note• If the Tab Selection screen is not displayed, press the Menu button.3. Press the OK button.The Set./Adj. Menu is displayed.Adjustments for Better Print Quality > Adjusting the feed amount >iPF650 Automatic Banding Adjustment (Adj. Quality)7617
