| 
© 2004 - 2010 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO200L/202L/203L/230/230L/232/233/280/282/283ERROR CODE AND SELF-DIAGNOSTIC MODE2 - 472Notes:• The digit after the hyphen in “Code” of the following table is a sub code.• In “RAM”, the NVRAM of the board in which the data of each code is stored is indicated. “M”stands for the LGC board and “SYS” stands for the SYS board.Adjustment mode (05) Code Classi-fication Items Func-tionDefaultablevalue>RAM Contents Proce-dure200 Devel-operAutomatic adjustment ofauto-toner sensor(Fuser heater ON)ALL - - As the value increases,the sensor outputincreases correspond-ingly.The value starts chang-ing approx. 2 minutesafter this adjustment wasstarted and is automati-cally set in the range of2.35 to 2.45 V.* Selection is disablewhen developer unitis not installed.(Chap. 3.1)17201 Devel-operCorrection of auto-tonersensor(Fuser heater ON)ALL 164<0-255>M Corrects the controlvalue of the auto-tonersensor setup in 05-200.* Selection is disablewhen developer unitis not installed.3205 Devel-operDeveloper bias DC outputadjustmentALL 135<0-255>M As the value increases,the transformer outputincreases correspond-ingly. Remove the devel-oper unit and install theadjustment jig to makeadjustment.(Chap. 3.6)3210 Charger Main charger grid bias out-put adjustmentALL 90<0-255>M 3220 Transfer Transfer transformer DCoutput adjustment (H)ALL 165<0-255>M 3221 Transfer Transfer transformer DCoutput adjustment (C)ALL 179<0-255>M 3222 Transfer Transfer transformer DCoutput adjustment (L)ALL 126<0-255>M 3233 Separa-tionSeparation transformer DCoutput adjustment (H)ALL 64<0-255>M 3234 Separa-tionSeparation transformer DCoutput adjustment (C)ALL 65<0-255>M 3235 Separa-tionSeparation transformer DCoutput adjustment (L)ALL 46<0-255>M 3280 Process Forced performing of idlingfor toner recycleALL - M Perform this adjustmentbefore the replacementof the developer mate-rial. (The toner is forciblyremoved from thecleaner.)6286 Laser Laser power adjustment ALL 63<0-255>M When the valueincreases, the laser out-put increases corre-spondingly.3305 Scanner Image location adjustmentof secondary scanningdirection(scanner section)ALL 125<92-164>SYS When the valueincreases by “1”, theimage shifts by approx.0.137 mm toward thetrailing edge of thepaper.105/12 |
