Toshiba e-studio200l Service Handbook

Also see for e-STUDIO200L: User guide Operator's guide Service manual Service manual Service handbook

Contents

e-STUDIO200L/202L/203L/230/230L/232/233/280/282/283 © 2004 - 2010 TOSHIBA TEC CORPORATION All rights reservedFIRMWARE UPDATING6 - 4Important:• The download jig (PWA-DWNLD-350-JIG) has two types having different ROM capacity.ROM capacity for each jig is as follows.* “PWA-DWNLD-350-JIG2 (48 MB)” is substitutable for “PWA-DWNLD-350-JIG1 (16 MB)”• The download jig (PWA-DWNLD-350-JIG) is different type jig. The Flash ROM is installed onthe board directly. Therefore, ROM writer adapter (PWA-DL-ADP-350) is required to write thedata to these Flash ROMs. Refer to the following to write the data. P.6-21 "6.1.3 Writing the data to the download jig (PWA-DWNLD-350-JIG)"Fig. 6-3 Jig board: K-PWA-DLM-320Important:Pay attention to the direction of the ROM.Fig. 6-1 Jig board: PWA-DWNLD-350-JIG2 (48 MB) Fig. 6-2 Jig board: PWA-DWNLD-350-JIG1 (16 MB)Download jig ROM capacity ApplicationPWA-DWNLD-350-JIG2 (48 MB) 8 MB x 6 Updating the master dataPWA-DWNLD-350-JIG1 (16 MB) 8 MB x 2 Updating the system ROM, engine ROM,scanner ROM, NIC ROMROM4ROM5ROM6ROM1ROM2ROM3Connector(for SYS boardconnection)Connector(for ROM writeradapter connection)ROM1ROM2Connector(for SYS boardconnection)Connector(for ROM writeradapter connection)Connector Mark for ROMinstallation directionROMLED