© 2004 - 2010 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO200L/202L/203L/230/230L/232/233/280/282/283TROUBLESHOOTING5 - 875[ 4 ] E-mail related error(when GM-1020/3020, GM-1030/3030, GM-2020, GM-2030, GM-1070/4070, GM-1080U/4080U,GM-2070, GM-2080U, GM-1071/4070, GM-1081U/4080U, GM-2071, GM-2081U, GM-1130/4130, GM-1140U/4140U, GM-2130, or GM-2140U is installed)[2C10] System access abnormality[2C32] File deletion failureTurn the power OFF and then back ON. Perform the job in error again.If the error still occurs, first, check if there are no jobs existing and then perform the HDD formatting (08-690).[2C11] Insufficient memoryWhen there are running jobs, perform the job in error again after the completion of the running jobs.If the error still occurs, turn the power OFF and then back ON, and perform the job again.[2C12] Message reception error[2C13] Message transmission errorTurn the power OFF and then back ON. Perform the job in error again.[2C14] Invalid parameterWhen a template is used, form the template again.If the error still occurs, turn the power OFF and then back ON, and perform the job again.[2C15] Exceeding file capacityReset and extend the “Message size limitation” or reduce the number of pages and perform the jobagain.[2C20] System management module access abnormality[2C21] Job control module access abnormality[2C22] Job control module access abnormalityTurn the power OFF and then back ON. Perform the job in error again.Check if there are no other running jobs and perform the HDD formatting (08-690).If the recovery is still not completed, replace the SYS board.[2C30] Directory creation failure[2C31] File creation failure[2C33] File access failureCheck if the access privilege to the storage directory is writable.Check if the server or local disk has a sufficient space in disk capacity.[2C40] Image conversion abnormality[2C62] Memory acquiring failureTurn the power OFF and then back ON. Perform the job in error again.Replace the main memory and perform the job again.07/11
