© 2004 - 2010 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO200L/202L/203L/230/230L/232/233/280/282/283FIRMWARE UPDATING6 - 876Important:• Only the USB storage device which meets the following conditions should be used for updat-ing. Be careful since updating with any device other than the above is never guaranteed.- A combination USB storage device with a flash memory (to be connected directly to theUSB port) and its capacity is between 64 MB to 512 MB (or 1 GB).- Operation of the USB storage device used for updating has been confirmed at the inputcheck of this equipment (Test mode 03).( P.2-32 "2.2.2 Input check (Test mode 03) (e-STUDIO202L/203L/232/233/282/283)")- A USB storage device which is complied with the following standards regulated by USB-IF(USB Implementers Forum)Class number: 8 (=08h) (Mass-storage class)Sub-class number: 6 (=06h) (SCSI transfer command set)Protocol number: 80 (=50h) (Bulk-Only)* Most common USB storage devices are complied with the specification above and canbe used for updating. However, the operation in all the Multi Functional Digital ColorSystems and Multi Functional Digital Systems is not necessarily guaranteed since themost of these devices are developed based on the use in PC environment (Windows orMacintosh). Therefore, confirm thoroughly that the device is operational in the equip-ment for which the updating will be performed when purchasing the device.• The data file for updating is stored in the model specific folder.Never change the model specific folder name since it is used for discriminating the data filewhen the updating data files for multiple models are stored in the USB storage device.• Store the model specific folder in the root directory of the USB storage device.• Storing the data file directly in the root directory is possible when the updating data files forone specific model is stored in the USB storage device.However, if the model specific folder for the same model as that of the data file stored in theroot directory already exists, the model specific folder will have the priority.• The USB storage device complied with USB1.1 and USB2.0 can be used for updating. How-ever, the update is performed in the speed of USB1.1 when the device complied with USB2.0is used.• Do not update the firmware by any storage device other than a flash memory (such as a USBconnection type memory card reader, CD/DVD drive or hard disk) since it is never guaran-teed.07/11
