© 2004 - 2010 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO200L/202L/203L/230/230L/232/233/280/282/283TROUBLESHOOTING5 - 375[ 3 ] Paper jam in finisher section[EA10] Paper transport delay jamMJ-1022Is there any paper remaining on the transport path in the finisher or equipment? YES Remove the paper.NOIs the connector J10 on the finisher controller PC board disconnected?Is the harness connecting the finisher controller PC board and inlet sensor (S2) open cir-cuited? YES Connect the connector securely. Replace the harness.NOIs the inlet sensor working normally? (Check the movement of the actuator.)llNO 1) Connect the connector of the inlet sensor securely.2) Attach the actuator securely if its shaft is out of place.3) Replace the inlet sensor.YESReplace the finisher controller PC board.MJ-1025Is there any paper remaining on the transport path in the finisher or equipment? YES Remove the paper.NOIs the connector CN16 (inlet sensor) on the finisher controller PC board disconnected?Is the harness connecting the finisher controller PC board and inlet sensor open-circuited? YES Connect the connector securely. Replace the harness.NOIs the inlet sensor working normally? (Check the movement of the actuator.)lNO 1) Attach the actuator securely if its shaft is out of place.2) Replace the sensor.YESReplace the finisher controller PC board.
