© 2004 - 2010 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO200L/202L/203L/230/230L/232/233/280/282/283TROUBLESHOOTING5 - 115[E950] Jam not reaching the JSP feed sensor[E951] Stop jam at the JSP feed sensorOpen the JSP cover. Is there any paper on the transport path? YES Remove the paper.NOIs the JSP feed sensor working?(Perform the input check in the test mode: 03-[FAX]ON/[3]/[H])lllllllllllNO 1) Check if the connector of the JSP feed sensor is disconnected.2) Check if either of the connectors CN260 or CN262 on the JSP boardis disconnected.3) Check if the connector CN306 on the LGC board is disconnected.4) Check if the connector pins are disconnected and the harnesses areopen circuited.5) Check if the conductor patterns on the JSP board and LGC board areshort circuited or open circuited.6) Replace the JSP feed sensor.7) Replace the JSP board.8) Replace the LGC board.YES1) Replace the JSP board.2) Replace the LGC board.[E960] Jam not reaching the OCT feed sensor[E961] Stop jam at the OCT feed sensorOpen the OCT cover. Is there any paper on the transport path? YES Remove the paper.NOIs the OCT feed sensor working?(Perform the input check in the test mode: 03-[FAX]ON/[3]/[H])lllllllllllNO 1) Check if the connector of the OCT feed sensor is disconnected.2) Check if either of the connectors CN260 or CN262 on the OCT boardis disconnected.3) Check if the connector CN306 on the LGC board is disconnected.4) Check if the connector pins are disconnected and the harnesses areopen circuited.5) Check if the conductor patterns on the OCT board and LGC boardare short circuited or open circuited.6) Replace the OCT feed sensor.7) Replace the OCT board.8) Replace the LGC board.YES1) Replace the OCT board.2) Replace the LGC board.
