Toshiba e-studio200l Service Handbook

Also see for e-STUDIO200L: User guide Operator's guide Service manual Service manual Service handbook

Contents

© 2004 - 2010 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO200L/202L/203L/230/230L/232/233/280/282/283FIRMWARE UPDATING6 - 576Note:Note:Record the current settings of the DIP switch before changing them. After the updating is com-pleted, return the DIP switch to the status as record.Fig. 6-62(6) Turn ON the power while [0] button and [8] button are pressed simultaneously.Updating starts automatically and the LED on the download jig lights.(7) After the update is completed properly, the LED on the download jig blinks slowly. The LED startsblinking in approx. 20 sec. since the update starts. It is assumed that the update is failed if it doesnot start blinking even though 1 min. has passed, or LED flashes fast. In this case, turn OFF thepower and check the following items. Then, clear the problem and restart updating from thebeginning.• Is the download jig connected properly?• Is the ROM installed to the download jig properly?• Is the updating data written on the ROM of the download jig properly?• Do the download jig and the equipment operate properly?• Is the DIP switch on the finisher control PC board set properly?(8) Turn OFF the power, remove the download jig and return the DIP switch to the status beforeupdating.(9) Install the finisher rear cover.05/11