March 2000 © TOSHIBA TEC 4-23 DP120F/DP125F Function Settings1.2.17 Redial Mode [MENU], [4], [1], [14]This setting is performed to select the automatic redial interval and specify the number redialattempts to be made when communication is not completed properly because the line is busy ora communication error occurs.(1) Use the [ ↑ ] or [ ↓ ] keys to select one of the two options (INTERVAL and COUNTER),then press the [ENTER] key.When “01.INTERVAL” is selected, the screen below is displayed. Enter a value from 01 to15 (in units of minutes) as the redial interval, then press the [ENTER] key. When any value outside the specified range is entered, it must be set again.When “02.COUNTER” is selected, the screen below is displayed. Enter 00 to 14 as thecounter value, then press the [ENTER] key. When “0” is entered, no redialing will occur. When any value outside the specified range is entered, it must be set again.REDIAL MODE01.INTERVAL02.COUNTERREDIAL MODEINTERVAL =(01-15MIN)01REDIAL MODECOUNTER =(00-14)02(2) After the “OPERATION COMPLETED” message is displayed, press the [STOP] key toreturn to the Standby Mode screen.
