DP120F/DP125F Troubleshooting 11-2 March 2000 © TOSHIBA TEC1.1 AUTO TEST [MENU], [9], [1]In AUTO TEST mode, the user himself follows the procedure to automatically perform a seriesof test items in succession.NOTE: AUTO TEST cannot be performed if the data, such as received data, delayedtransmission, or polling data, is stored in the memory.The test items to be performed in AUTO TEST mode are as follows:• FLASH ROM TESTChecks the firmware, function data, and language data stored in the Flash ROM.• SRAM TESTPerforms a read/write test on the SRAM.(For the contents of the test, refer to “1.5.5 SRAM TEST” on page 11-22.)• DRAM TESTPerforms a read/write test on the DRAM.(For the contents of the test, refer to “1.5.6 DRAM TEST” on page 11-23.)• MODEM TEST (Line 1, Line 2: Only when installed)Performs a read/write test on the MODEM register and detects a line current.• SCANNER TESTTests the image scanning operation of the CIS and performs a read/write test on the internalmemory of the DSC.(For the contents of the test, refer to “1.5.8 SCANNER TEST” on page 11-24.)• CODEC TESTTests the coding/decoding operation of the CODEC.(For the contents of the test, refer to “1.5.9 CODEC TEST” on page 11-25.)• PRINTER TESTPrints a test pattern sheet to check the operation of each section (HVPS, LSU, Fuser, and soon) of the printer.• PHONE BOOK DATA TESTChecks the data of the phone book.• NET. BOARD TEST (Only when the GF-1010 is installed)Checks the GF-1010 (Optional NIC.)(For the contents of the test, refer to “1.5.10 NET. BOARD TEST” on page 11-25.)• PCL BOARD TEST (Only when the GA-1020 is installed)Checks the GA-1020 (Optional PCL board.)(For the contents of the test, refer to “1.5.11 PCL BOARD TEST” on page 11-26.)
