March 2000 © TOSHIBA TEC 8-47 DP120F/DP125F Removal/Replacement01/12(10) Reassemble the components in the reverse order of disassembly.CAUTION: • There is a danger of a component explosion, if the battery is incor-rectly replaced. Replace only with the same or equivalent type recom-mended by the manufacturer. Dispose of used batteries according tothe manufacturer’s instructions.NOTES: • Carefully handle the boards that are directly connected together to avoiddamaging the connectors and boards.• After reassembling, turn the power switch ON, and execute and confirmthe following:- Perform the memory clear (ALL) referring to the “Chapter 11:1.6.1MEMORY CLEAR” on page 11-27.- Set the country/region where the machine is used referring to the “3.4Country/Region Setting” on page 8-135.- According to the pre-output lists of the registration and programming,set the function again.- Perform the edge registration adjustment referring to the “3.3 Edge Reg-istration” on page 8-134.- Set the fuser rank referring to the “3.2 Fuser Temperature Settings” onpage 8-133.- Reset all counter data in the memory write mode using the hex dataprovided on the communication journal referring to the “Chapter 11:1.6.3MEMORY WRITE” on page 11-30.SCAN COUNT : F052EA — F052EDPRINT COUNT : F052F2 — F052F5DRUM COUNT : F0534E — F05351
