DP120F/DP125F Troubleshooting 11-30 March 2000 © TOSHIBA TEC1.6.3 MEMORY WRITE [MENU], [9], [5], [03]This setting is used to change the contents of a specific backup RAM address (using a 6-digitHEX code). Enter the desired address from the dial keypad, and then press the [ENTER] key.The address is incremented by pressing the [ENTER] key.WARNING: Under normal circumstances it is not necessary to make changes tothe memory write addresses. It is recommended that changes to thesesettings be made only in response to a specific instruction from aToshiba service representative, service bulletin, or other publication.(1) Use the [ ↑ ] or [ ↓ ] key to select "03.MEMORY WRITE," and then press the [ENTER] key.(2) Enter the desired 6-digit address for inputting data, and then press the [ENTER] key. To enter the value, use the following keys,0 to 9: Dial keysA to F: One touch key 01 to 06 Be sure to enter the address in the range from 000000 to FFFFFF in HEXcode.(3) Enter the data, and then press the [ENTER] key.(4) The screen then increments to the next address. After setting, press the [STOP] key toreturn to the standby mode screen.MEMORY WRITEADDRESS =MEMORY WRITEADDRESS =XXXXXXDATA = YYMEMORY WRITEADDRESS =XXXXXXDATA = ZZ
