March 2000 © TOSHIBA TEC 11-33 DP120F/DP125F Troubleshooting1.6.6 EDGE REGISTRATION [MENU], [9], [5], [06]This setting adjusts the recording start position (lead edge and side edge) if incorrect due tomechanical dispersion. Do this adjustment when the Main PBA is replaced or when MEMORYCLEAR is performed. Do it also when the LSU is replaced if necessary. For the adjustment value of edge registration, refer to "Chapter 8 Removal/Replacement/Adjustment" on page 8-134.(1) Use the [ ↑ ] or [ ↓ ] key to select "06.EDGE REGISTRATION", and then press the [EN-TER] key.(2) Use the [ ↑ ] or [ ↓ ] key to set the LEAD EDGE (upper side), and then press the [ENTER]key. Pressing the [ ↑ ] key will move the image up 0.5mm per step.Pressing the [ ↓ ] key will move the image down 0.5mm per step. The setting range is -8.0mm to +8.0mm.(3) Use the [ ↑ ] or [ ↓ ] key to set the SIDE EDGE (left side), and then press the [ENTER] key. Pressing the [ ↑ ] key will move the image left 0.5mm per step.Pressing the [ ↓ ] key will move the image right 0.5mm per step. The setting range is -6.0mm (Left) to +8.0mm (Right.)(4) The display shows the screen below, then returns to the standby mode screen.↑ Feed direc-tionEffective record-ing areaRecordingpaperLead edgeSide edgeSIDE EDGE[↑↓] FOR SETTING+0.0mmLEAD EDGE[↑↓] FOR SETTING+0.0mmCOMPLETED
