Siemens SINUMERIK Series Function Manual

Also see for SINUMERIK 828D Turning: Diagnostic manual Function manual Equipment manual Programming manual Operating manual

H1: Manual and handwheel travel3.10 Start-up: HandwheelsExtended Functions206 Function Manual, 03/2013, 6FC5397-1BP40-3BA13.10.5 Connected via Ethernet (only 840D sl)Parameter settingThe parameters for handwheels connected via Ethernet modules, e.g. machine control panel"MCP 483C IE", "HT 8", or "HT 2", are assigned in the following NC machine data:● MD11350 $MN_HANDWHEEL_SEGMENT[< x - 1 >] = 7When connected via Ethernet modules, the segment always has to be entered as 7(Ethernet).● MD11351 $MN_HANDWHEEL_MODULE[< x - 1 >] = 1When connected via Ethernet modules, the module always has to be entered as 1.● MD11352 $MN_HANDWHEEL_INPUT[< x - 1 >] = ywhere y = 1, 2, 3, etc. (handwheel interface at the Ethernet bus)where x = 1, 2, 3, etc. (handwheel number in the NC)Handwheel interfaces at the Ethernet BusThe handwheel interfaces at the Ethernet bus are numbered on the basis of the followingconsiderations:● The sequence of the operator component interfaces is: MCP1, MCP2, BHG● Each operator component interface has two handwheel interfaces● Operator components: MCP 483C IEA maximum of two handwheels can be connected to an MCP 483C IE via connectionsX60 and X61 . The assignment of the connections in the operator component interface is:– Connection X60: 1st handwheel in operator component interface MCP1 /MCP2– Connection X61: 2nd handwheel in operator component interface MCP1 /MCP2● Operator components: HT 8The handwheel of the HT 8 is always assigned to the 1st handwheel of operatorcomponent interface MCP1 /MCP2 .● Operator components: HT 2The handwheel of the HT 2 is always assigned to the 1st handwheel of operatorcomponent interface BHG .