Panasonic WJ-HD500 Operating Instructions Manual

Also see for WJHD500 - DIGITAL DISC RECORDE: Operating instructions Instructions Service manual

Contents

Panasonic WJ-HD500 Operating Instructions Manual Manual pdf 59 page image

61The proceudures described below let you set the parame-ters for the Disk Recorder to communicate with externaldevices.1. Move the cursor to COMMUNICATION SETUP in theWJ-HD500 SETUP menu by pressing the C or D but-ton, then press the SET button.The COMMUNICATION SETUP menu shown belowappears on the monitor screen.2. Select an item or item parameter in the menu by press-ing the D or C button.3. To return to the previous WJ-HD500 SETUP menu,press the SET UP/ESC button. PS Data SetupThese items let you set the parameters for communicationbetween the System Controllers and the Disk Recorderswhen the system is controlled with the PS Data mode(Panasonic Security Data).1. Move the cursor to PS • Data SETUP in the COMMUNI-CATION SETUP menu by pressing the C or D button,then press the SET button.The PS • Data SETUP menu shown below appears onthe monitor screen.2. Select an item or item parameter in the menu by press-ing the D or C button.3. To return to the previous setup menu, press the SETUP/ESC button. Unit Address SettingThis item lets you set the unit address of the Disk Recorderin the system for RS-485 communication.1. Move the cursor to the UNIT ADDRESS parameter bypressing the D or C button.2. Select the unit address number to be used for RS-485communication by pressing the + or - button.Select a parameter value between 001 and 098.The factory default setting is 001. Baud RateThis item lets you set the transmission speed for RS-485communication.1. Move the cursor to the BAUD RATE parameter bypressing the D or C button.2. Select the desired transmission speed shown below bypressing the + or - button.8 COMMUNICATION SETUPPS•Data SETUPRS232C SETUPNETWORK SETUPIP ADDRESS 192.168.000.010NETMASK 255.255.255.000GATEWAY 192.168.000.0018-1 PS•Data SETUPUNIT ADDRESS 001BAUD RATE 9600DATA BIT 8PARITY CHECK NONESTOP BIT 1WAIT TIME OFFALARM DATA 1SCAMERA NUMBER SETUP↔ 2 400 ↔ 4 800 ↔ 9 600 ↔19 200 ↔ 38 400 ↔The factory default setting is 9 600 bps. Data BitThis item lets you set the number of data bits for RS-485communication.The factory default setting is 8 bits and fixed.COMMUNICATION SETUP