Panasonic WJ-HD500 Operating Instructions Manual

Also see for WJHD500 - DIGITAL DISC RECORDE: Operating instructions Instructions Service manual

Contents

Panasonic WJ-HD500 Operating Instructions Manual Manual pdf 62 page image

64 Stop BitThis item lets you set the number of stop bits for RS-232Ccommunication.1. Move the cursor to the STOP BIT parameter by press-ing the D or C button.2. Select either 1 or 2 for the number of stop bits by press-ing the + or - button.The factory default setting is 1 bit. Wait TimeThis item lets you set the waiting time in milli-seconds (ms)to retry after confirming that no data is received from thecontroller for RS-232C communication.1. Move the cursor to the WAIT TIME parameter by press-ing the D or C button.2. Select OFF, 100, 200, 400, 1 000 ms for the wait time bypressing the + or - button.When no transmission is needed, select OFF.The factory default setting is OFF (no retry). Flow ControlThis item lets you enable or disable the flow control for RS-232C communication.1. Move the cursor to the X ON/X OFF parameter bypressing the D or C button.2. Select either mode by pressing the + or - button.NOT USE: Disables flow control with X ON/X OFF code.USE: Enables flow control with X ON/X OFF code.The factory default setting is NOT USE. Network SetupWhen the optional Network Interface Board is installed inthe Disk Recorder, the Disk Recorder can be controlledfrom a Client PC via the Ethernet Hub.These items let you set the parameters for communicationbetween the 10/100BASE-T port of the Disk Recorder andoutboard device via Ethernet.1. Move the cursor to IP ADDRESS in the COMMUNICA-TION SETUP menu by pressing the C or D button,then press the SET button.The cursor moves to the right editing area.2. Select the value for the IP Address by pressing the +or - button.3. Move the cursor to the right by pressing the B button,then select the value for the IP Address by pressing the+ or - button.4. Repeat the above steps 2 and 3 until the IP Address iscompleted.5. When the IP Address is completed, press the SETUP/ESC button to return the cursor to IP ADDRESS inthe menu.6. Similarly repeat the above steps 1 to 5 to set theNetmask and Gateway.7. To return to the previous setup menu, press the SETUP/ESC button.