Panasonic WJ-HD500 Operating Instructions Manual

Also see for WJHD500 - DIGITAL DISC RECORDE: Operating instructions Instructions Service manual

Contents

Panasonic WJ-HD500 Operating Instructions Manual Manual pdf 65 page image

672. To return to the previous setup menu, press the SETUP/ESC button. Disk Space IndicatorThis item lets you determine the indication mode for theFULL indicator when the remaining storage capacity is run-ning low on the Hard Disk.1. Move the cursor to the HDD FULL parameter in theDISK MANAGEMENT menu by pressing the C or Dbutton.2. Select the desired indicator mode by pressing the + or- button.OFF: No warning for remaining space1 - 10%: The selected warning is issued if the remain-ing storage capacity is between 1 and 10%.The factory default setting is 1%.Note: This setting is applied to the display on the moni-tor screen and signal output from the CONTROLport.9-3-1 DISK INFO HDD TOTAL:520GBHOURS HOURS HOURS HOURSMAIN 1:30000 2:30000EXT5 1:30000 2:30000 3:30000 4:30000EXT4 1:* 2:* 3:* 4:*EXT3 1:- 2:- 3:- 4:-EXT2 1:- 2:- 3:- 4:-EXT1 1:- 2:- 3:- 4:-EXT0 1:- 2:- 3:- 4:-EXT DVD:OKFORMAT:HD500 LEFT10% 30GBDATA :SEP12.99 12:25 SEP12.99 16:25STATUS:OK• When the saving is completed, the display will return tothe previous SYSTEM SETUP menu. Disk ManagementThe Hard Disk status can be displayed on the monitorscreen.1. Move the cursor to DISK MANAGEMENT in the SYSTEMSETUP menu by pressing the C or D button, thenpress the SET button.The DISK MANAGEMENT menu shown below appearson the monitor.9-1 USER DEFINED SETUPLOAD USER DEFINED SETUPLOADING COMPLETE!9-2 USER DEFINED SETUPSAVE USER DEFINED SETUPSAVING COMPLETE!2. Select an item or item parameter in the menu by press-ing the D or C button.3. To return to the previous setup menu, press the SETUP/ESC button. Disk Information1. Move the cursor to DISK INFORMATION in the DISKMANAGEMENT menu by pressing the C or D button,then press the SET button.The DISK INFORMATION table appears on the monitor,as shown below.9-3 DISK MANAGEMENTDISK INFORMATIONHDD FULL 1%ERASE4. Select either YES or NO by pressing the + or - but-ton.Select YES, then press the SET button to execute theselection (save or load).The display shown below appears on the monitor