Panasonic WJ-HD500 Operating Instructions Manual

Also see for WJHD500 - DIGITAL DISC RECORDE: Operating instructions Instructions Service manual

Contents

Panasonic WJ-HD500 Operating Instructions Manual Manual pdf 53 page image

551. Move the cursor to ALARM SETUP in the WJ-HD500SETUP menu by pressing the D or C button, thenpress the SET button.The ALARM SETUP menu shown below appears on themonitor screen.2. Select an item or item parameter in the menu by press-ing the D or C button.3. To return to the previous WJ-HD500 SETUP menu,press the SET UP/ESC button. Alarm Port SettingThis item lets you designate the alarm input from theALARM port located on the rear of the Disk Recorder.1. Move the cursor to ALARM TERMINAL SETUP in theALARM SETUP menu by pressing the D or C button,then press the SET button.The table shown below appears on the monitor screen.6 ALARM SETUPALARM TERMINAL SETUPAUTO RESET OFFALARM OUTPUT 2SALARM BUZZER 2SVIDEO LOSS ONVIDEO MONITOR DETECTION OFFVMD AREA SETUPALARM MODE MULTI OUTPUT SPOTSPOT OUTPUT SPOT6-1 ALARM TERMINAL SETUPALM CAM INPUT ALM CAM INPUT1CH 1 N•O 9CH 9 N•O2CH 2 N•O 10CH 10 N•O3CH 3 N•O 11CH 11 N•O4CH 4 N•O 12CH 12 N•O5CH 5 N•O 13CH 13 N•O6CH 6 N•O 14CH 14 N•O7CH 7 N•O 15CH 15 N•O8CH 8 N•O 16CH 16 N•O2. Move the cursor to the input channel editing area bypressing the A, B, D or C button.3. Select a camera number (1 - 16) corresponding to theinput for the CAM editing area by pressing the + or -button.4. Move the cursor to the INPUT editing area by pressingthe B button, then select the type of contact to meetthe system requirement by pressing the + or - but-ton.N.O: Accepts alarm input from Normally Open con-tacts.N.C: Accepts alarm input from Normally Closed con-tacts.The factory default setting is N.O.5. Repeat the above steps 2 to 4 to designate the otherinput channels.6. When satisfied with all of the above steps, press theSET UP/ESC button to return to the previous ALARMSETUP menu. Alarm Auto Reset SettingThis item lets you select the duration the Disk Recorderretains the alarm mode before resetting automatically.1. Move the cursor to the AUTO RESET parameter in theALARM SETUP menu by pressing the D or C button.2. Select the desired duration by pressing the + or -button.OFF: Disables auto reset.1S - 30S, 40S, 50S, 1M -5M: Selects an alarm durationbetween 1 second and 5 minutes.The factory default setting is OFF. Alarm Output SettingThis item lets you select the output duration of the alarmsignal from the ALARM port.1. Move the cursor to the ALARM OUTPUT parameter inthe ALARM SETUP menu by pressing the D or C but-ton.2. Select the desired duration by pressing the + or -button.OFF: Disables alarm output, regardless of an incomingalarm.1S - 30S, 40S, 50S, 1M -5M: Selects an alarm durationbetween 1 second and 5 minutes.EXT: Alarm output continues until the ALARM RESETbutton is pressed or the external alarm recover sig-nal is received from the ALARM port.ALARM SETUP