English78Using NetworkFunctionThis unit has a network function and you can control theDisplay connected to the network using your computer.Necessary environment forcomputers to be connectedFirst of all, confirm your computer whether it has a wiredLAN.Before connecting the Display to the computer, be sureto check the following settings.Check 1: About LAN cable● Connect the cable properly.● Use LAN cable that is compatible with category 5 orabove.Check 2: Wired LAN settingsComputer with a built-in wired LAN function● Switch on the wired LAN.Computer without a built-in wired LAN function● Check that your wired LAN adapter is recognizedproperly and it is switched on.● Install the wired LAN adapter driver beforehand.For details on how to install the driver, refer to theinstructions accompanying the wired LAN adapter.■ About Web BrowserWeb Browser is necessary to use WEB control.● Compatible OS:Windows, Mac OS● Compatible Web Browser:Internet Explorer 7.0 / 8.0 / 9.0 / 10.0 / 11.0(Windows)Safari 4.x / 5.x / 6.x (Mac OS)Example of network connectionNote● To use the network function, set each item in[Network settings] and make sure to set [Networkcontrol] to [On].(see page 59)When it is set to [On], power indicator lights orangeunder the condition of power “Off” with remote control(stand-by state).■ LAN Terminal connectionDIGITAL LINK*1 *2*1: TH-65SF2E*2: TH-65SF2U, TH-55SF2U, TH-49SF2U, TH-43SF2U,TH-55SF2E, TH-49SF2E, TH-43SF2EDisplay (Back of the unit)PCDIGITAL LINK / LAN TerminalLAN cable (commercially available)Hub or broadband routerNote● For LAN cable, use shielded cable, otherwise picturenoise may be caused.● Make sure the broadband router or hub supports100BASE-TX.● Touching the LAN Terminal with a statically chargedhand (body) may cause damage to the device due toits discharge.Do not touch the LAN Terminal or the metal part ofthe LAN cable.● For instructions on connection, consult your networkadministrator.