Panasonic TH-65SF2U Operating Instructions Manual

Also see for TH-43SF2E: Operating Instructions - Basic Guide

Contents

Panasonic TH-65SF2U Operating Instructions Manual Manual pdf 100 page image

English100Starting / ending Media Player■ For Single Media PlayerStart1. Insert the USB memory device for Media Playerto the USB terminal on the side of the display.Note● Depending on the type of a USB memory device,it may come in contact with the periphery suchas a back cover, and cannot be attached. Use acommercially sold extension cable, or use a smalltype of a USB memory device connectable to thisunit.USB memoryUSB terminal2. Run a USB memory contents check.3. Change INPUT to [USB].EndingChange INPUT to other than [USB].■ For Multi Media PlayerStart1. Connect several units with LAN cables.(See “Example of setting up LAN connection and IPaddress / Subnet mask” in the previous section.)2. Insert USB memory for Media Player into eachDisplay.3. Executes USB memory contents check on eachDisplay.4. Change INPUT for Child to [USB].5. Change INPUT for Parent to [USB].EndingChange INPUT for Parent to other than [USB].Resume Play functionAfter Media Player ends, the file to be played back nexttime varies depending on the setting of [USB mediaplayer settings] - [Resume play].When set to [On]:The file played prior to the end of Media Player startsplaying from the beginning.When set to [Off]:Play starts from the beginning of the first file of thescenario.Note● The resume play function is retained until the unit isturned off or the USB memory device is taken out.Schedule playback function using“Content Management Software”This unit supports “Content Management Software” tocreate schedule data on a PC required to play back stillpictures and motion pictures.Functions that can be set with “Content ManagementSoftware” are as follows.• Content playback (Still pictures/Motion pictures)• Music playback• Input switch• Power control• Multi display settingNote● To use this function, set [USB media player] and[Schedule play function] to [Enable] in [Setup] - [USBmedia player settings].● About supported devices, refer to “Supported device”.(see page 95)● If both the scenario file of the “USB media player” andthe schedule data of this function are present on theUSB memory device, the [Schedule play function]operation takes priority.● When using this function, insert the USB memorydevice in power-on state or in schedule standby state.If the USB memory device is inserted in conditionsother than the said states, the schedule playback isnot performed.● Functions restricted when using the “USB mediaplayer” are also restricted when using the scheduleplayback function.