Panasonic TH-65SF2U Operating Instructions Manual

Also see for TH-43SF2E: Operating Instructions - Basic Guide

Contents

Panasonic TH-65SF2U Operating Instructions Manual Manual pdf 32 page image

English32Note● Displays the signal name as set in [Input label]. (seepage 51)● Input will not be switched unless [Input lock] is set to[Off]. (see page 73)● Image retention (image lag) may occur on the LCDliquid crystal panel when a still picture is kept onthe panel for an extended period. To prevent sucha problem, using the screensaver and wobbling isrecommended. (see page 50, 55)RECALLIt is possible to check the setting status of input label,picture mode, etc.Press .Current setting status will be displayed.12783456HDMI116:9AV INMemory name: MEMORY2Schedule play modeOff timer 90 minBackup mode OK1 Input label2 Aspect mode (see page 34)3 Backup input change (see page 70, 71)4 Audio input (see page 72)5 Profile name (see page 46)6 [Schedule play mode] (see page 101)7 Off timer remaining time (see page 33)8 Clock / Mute (see page 33, 76)● When there is no video signal to the selected input,[No signal] is displayed for about 30 seconds at theend.● When a USB memory is not connected to the USBterminal at the time of switching to the USB input, [Noexternal media] is displayed for about 30 seconds.Even when a USB memory is connected, if it does notcontain any playable file, [No play file] is displayed atall times.● When [No signal image settings] - [Display setting] isset to [On] (see page 54), the message [No signal] /[No external media] / [No play file] are not displayed.Instead, the image set in [No signal image settings]will be displayed.● To display the clock, set [Date and time] and then set[Clock display] to [On]. (see page 57, 76)Volume AdjustmentPress or <+ (Unit)> <- (Unit)> toadjust volume.INPUTMENUENTERUnit20Volume (SPEAKERS)● The current sound volume level is memorised even ifthe power is turned off.● When [Maximum VOL function] is set to [On], thevolume can only be adjusted to the maximum pointyou set, and the displayed value turns red when itreached its maximum. (see page 73)● When [Initial VOL function] is set to [On], the volumewill be at the set level when the display is turned on.(see page 72)