Panasonic TH-65SF2U Operating Instructions Manual

Also see for TH-43SF2E: Operating Instructions - Basic Guide

Contents

Panasonic TH-65SF2U Operating Instructions Manual Manual pdf 30 page image

English301 Connect the AC cord plug to theDisplay.(see page 15)2 Connect the plug to the socket outlet.Note● Main plug types vary between countries. Thepower plug shown at left may, therefore, not be thetype fitted to your set.● When disconnecting the AC cord, be absolutelysure to disconnect the AC cord plug at the socketoutlet first.● The settings may not be saved if the power plug isdisconnected immediately after changing settingswith on-screen menu. Disconnect the power plugafter a enough period of time. Or, disconnect thepower plug after turning the power off with theremote control, RS-232C control or LAN control.3 Press the

button> on the unit to turn the set on:Power-On.● Power Indicator: Green (Picture is displayed.)● When the power of the unit is ON, remote controloperation is possible.■ To turn the power ON/OFF with the remotecontrolPress the to turn theDisplay on.● Power Indicator: Green (Picture is displayed.)Press the to turn theDisplay off.● Power Indicator: Red (standby)Press the

on the unit toturn the unit off, when the power of the unit is turnedon or in standby mode.Note● During operation of the “Power management” function(see page 51), the power indicator turns orange in thepower off state.● After the power plug is disconnected, the powerindicator may remain lit for a while. This is not amalfunction.Basic ControlsRemote Control Sensor /Power IndicatorMain Power On / Off button(Back of the unit)AC socket outletAC cord (supplied)Operate pointing the remote control directly atthe unit’s Remote Control Sensor.Note● For normal use, pull out the remote control sensorfrom the edge side of the main unit by operating thelever on the rear panel. (see page 28)● Do not put an obstacle between the remote controlsensor of the main unit and the remote control.● Operate the remote control in front of the remotecontrol sensor or from the area where the sensor canbe seen.● When directly aiming the remote control at the remotecontrol sensor of the main unit, the distance fromthe front of remote control sensor should be approx.7 m or less. Depending on the angle, the operationdistance may be shorter.● Do not subject the remote control sensor of the mainunit to the direct sunlight or strong fluorescent light.