Panasonic TH-65SF2U Operating Instructions Manual

Also see for TH-43SF2E: Operating Instructions - Basic Guide

Contents

Panasonic TH-65SF2U Operating Instructions Manual Manual pdf 49 page image

49English■ [XGA mode]This menu is displayed at PC IN input.This unit supports XGA signals (1024 x 768, 1280 x768, 1366 x 768) having different aspect ratios andsampling rates.[Auto]:Automatically detects the signal.Switch the setting to suit the input signal for betterdisplay depends on the angle of view or displayresolution condition.Note● After making this setting, be sure to make eachadjustment (such as [Auto setup]) on the [Position]menu as necessary. (see page 38)■ [Signal range]This menu is displayed at HDMI1, HDMI2, DIGITALLINK and DVI-D IN inputs. Switches the dynamicrange to match the signals from the source connectedto each terminal.[Video(16-235)]:If the input signal is the video rangeExample: HDMI terminal output for DVD player[Full(0-255)]:If the input signal is full rangeExample: HDMI terminal output for personalcomputer[Auto]:Switches the dynamic range automatically between[Video(16-235)] and [Full(0-255)] according to theinput signal.Note● [Auto] can be selected when HDMI or DIGITALLINK signal is input.■ [Input level]This menu is displayed at PC IN and AV IN inputs.Adjustment of parts which are extremely bright andhard to see.-16 ‒ +16:(Level low) ‒ (Level high)■ [3D Y/C filter]Set this if the video looks unnatural at AV IN input. Setthis to [On] normally.Note● Depending on the signalling system, this settingmay be less effective or may not be effective at all.■ [Colour system]Sets the colour system according to the signalmethod at AV IN input. Set this to [Auto] normally.This automatically detects the input signal format.[Auto], [PAL], [SECAM], [NTSC], [NTSC4.43],[PAL-M], [PAL-N]:Set this to [Auto] when viewing PAL-60 videos.When images are unstableWhen the system is set to [Auto], images becomeunstable in rare case under the condition that theinput signals are at low level or have many noises.In this case, set the system so it conforms with theinput signal format.■ [Dynamic backlight control]Improves picture contrast and alleviates whitenessby controlling the back light when signals with the lowaverage brightness level (APL) are input.[On]:The function is enabled.[Off]:The function is disabled.Note● When this function is operating, the on-screenbrightness becomes lower.● If the [Dynamic backlight control] setting is differentfor each input, the on-screen brightness may changeby switching input.● Depending on the displayed image, the screen mayflicker. If this annoys you, set [Dynamic backlightcontrol] to [Off].■ [Frame creation]( 65-inch model only)Improves motion picture quality. Select [Off] when themotion picture looks unnatural.[Off]:[Frame creation] is disabled.[On]:[Frame creation] is enabled.Note● [Frame creation] is a function for 65-inch models.This function is not available for 55/49/43-inchmodels.■ Input signal displayDisplays the frequency and the type of the currentinput signal.60.00 Hz74.18 MHz1080/60i33.72 kHzH-freq.V-freq.Dot clock freq.Signal formatDisplay range:Horizontal (15 kHz ‒ 135 kHz)Vertical (24 Hz ‒ 120 Hz)The dot clock frequency is displayed when Digital andPC signal are input.