English62■ [USB memory network settings]Sets whether to permit the network setting using theUSB memory device. (see page 114)[Permit]:Permits USB memory network settings.[Prohibit]:Prohibits USB memory network settings.Note● This function is set to [Permit] as factory default.● Once the network setting is done with USB memorydevice, this function is set to [Prohibit].■ [Reset]You can reset the network setting to the factory defaultof the Display.Select [Yes] with and press .Network settingsResetYes NoNote● The settings for [NTP synchronization], NTP serverand [Time zone] will be reset to the factory default.USB media player settingsSet for “USB media player”.For details of the function, refer to “USB media player”(see page 94).[USB media player settings] - submenu screenUSB media player settingsUSB media playerResume playScenario file checkNo scenario fileSlide show durationEnable10 secOnSchedule play function EnableVideo playback mode StandardSchedule play function default settingPlay mode Individual playCurrent setting Individual play■ [USB media player]Set to enable or disable the USB media playerfunction.■ [Schedule play function]Enables/Disables the schedule playback functionusing “Content Management Software”.Note● When [Schedule play function] is set to [Enable],if both the scenario file of the existing “USB mediaplayer” and the schedule file of this function arepresent, the [Schedule play function] operation takespriority.● [USB media player] cannot be changed during theschedule playback mode.■ [Video playback mode]Sets the video playback mode.If image disturbance occurs at the switching timingof motion picture files during playback in [Standard]mode, switch to [Adjust] mode.[Standard]: Plays without a black image at the jointbetween video files.[Adjust]: Plays with a black image (approx. 2seconds) inserted at the joint betweenvideo files.Note● When using the Multi Media Player, a black screen isdisplayed for a certain period of time at the switchingtiming of motion picture files regardless of the [Videoplayback mode] settings.● The display may be disturbed at the switching timingof files during playback in [Standard] mode.● When the schedule playback is proceeding using“Content Management Software”, [Video playbackmode] can be switched both in single mode and multimode.■ [Resume play]Set resume play off/on.■ [Scenario file check]Execute the contents check of the USB memorywhich is connected to the USB terminal. If any erroris detected, the error code and file name will bedisplayed.For details of the error codes, refer to “USB memorycontents check”. (see page 99)Select [Scenario file check] with and press.AvailableScenario file checkNote● When the schedule playback is proceeding using“Content Management Software”, [Scenario filecheck] is disabled.
