English60[Gateway]:(Gateway address display and setting)Enter a gateway address when DHCP server is notused.Note● When [DHCP] is set to [On], the IP address, etc. willbe displayed in grey.Entering numbersI192.168.000.008IP address1. Select the address and press .2. Select digits with .3. Change numbers with .4. Press .You can cancel the change by pressing.Select [Save] and press .Save the current network Setup.Note● To use a DHCP server, make sure the DHCPserver is started.● Contact your network administrator for details on[IP address], [Subnet mask] and [Gateway].● Shipping condition[DHCP]: Off[IP address]: 192.168.0.8[Subnet mask]: 255.255.255.0[Gateway]: 192.168.0.1[Port]Set the port number used for command control.Select [Port] and press to set the number.● The available setting range is 1024 ‒ 65535.● Entering numbers (see page 60)Note● When the PJLink protocol is used, the port setting isnot necessary.[MAC address]Displays the MAC address of this unit.■ [Network status]Checks the current Network settings status.192. 168. 0. 1255. 255. 255. 0192. 168. 0. 812:34:56:78:9A:BCNetwork statusDHCPIP addressSubnet maskGatewayMAC addressOff■ [DIGITAL LINK mode](TH-65SF2E only)Switches communication method of DIGITAL LINKterminal.[Auto]:Communication method is selected automatically.HDMI, LAN, serial communication are possible.Ethernet connection is possible.[DIGITAL LINK]:HDMI, LAN, serial communication are possible via atwisted pair cable transmitter.[Ethernet]:LAN communication is possible via the LAN terminalof the display.[Long reach]:Communication method is fixed to Long reach.Modes allowing communication: Valid― : InvalidSettingsCommunication validityPicturetransmission Ethernet RS-232C100 m 150 mAutoForDIGITALLINK―For Longreach ―ForEthernet ― ― ―DIGITAL LINK ―Long reach ―Ethernet ― ― ―Note● When connected with the [Long reach]communication method, the maximumtransmission distance is 150 m. In this case, thisunit can receive the signals of up to 1080/60p(148.5 MHz).● If the communication method of the twistedpair cable transmitter is set to [Long reach], set[DIGITAL LINK mode] to [Auto]. Then, connectionis enabled with the [Long reach] communicationmethod.When connecting with the separately sold DIGITALLINK Switcher (ET-YFB200G) with the [Longreach] communication method, set [DIGITAL LINKmode] to [Long reach].● Even if [DIGITAL LINK mode] is set to [Longreach], when the twisted pair cable transmitterdoes not support the communication method of[Long reach], it will not be connected properly.
